pdf-icon

DDS

SKU:U105

Description

DDS is a signal source Unit. It uses the AD9833 programmable waveform generator + STM32F0 micro controller. Based on I2C communication interface (addr:0x31) It can easily control the signal source to output multiple waveforms (sine wave, triangle wave, square wave output, sawtooth wave, signal output amplitude 0-0.6V) and adjust the frequency and phase.

It supports deep sleep mode, which can reduce the power consumption in the idle state. The Unit is suitable for the electronic circuit prototype design of various test instruments as a signal source.

Product Features

  • Digital programmable frequency and phase
  • Signal output amplitude 0-0.6V
  • Sine wave/Triangle wave/Square wave/Sawtooth wave (fixed frequency: 13.6KHz)/DC output
  • Output frequency range: 0MHz to 1MHz (10MHz based on the reference clock)
  • 28bit frequency resolution
  • 11bit phase resolution

Includes

  • 1x DDS Unit
  • 1x HY2.0-4P cable
  • 1x SMA-2.54mm cable

Application

  • Frequency stimulation/waveform generation
  • Liquid flow and airflow measurement
  • Sensor applications: proximity, motion and defect detection
  • Line loss/attenuation
  • Testing and medical equipment
  • Scan/clock generator
  • Time domain reflectometry (TDR) application

Specification

Specifications Parameter
Support waveform Sine wave/Triangle wave/Square wave/Sawtooth wave (fixed frequency: 13.6KHz)/DC output
Signal output amplitude 0-0.6V
Output frequency range 0MHz to 1MHz (10MHz based on the reference clock)
Frequency resolution 28bit
Phase resolution 11bit
Net weight 11.1g
Gross weight 34.7g
Product size 71*24*8mm
Package size 88.5*60*21mm

EasyLoader

EasyLoader is a concise and fast program writer, which has a built-in case program related to the product. It can be burned to the main control by simple steps to perform a series of function verification. Please install the corresponding driver according to the device type. M5Core host Please click here to view the CP210X driver installation tutorial

Download Windows Version Easyloader

Description:
Control DDS Unit Output Sine wave/Triangle wave/Square wave/Sawtooth wave.

Pin mapping

M5Core SCL SDA 5V GND
DDS Unit GPIO22 GPIO21 5V GND

Schematic

Example

Arduino

Protocol

  • Protocol type I2C
  • I2C Address: 0x31
Note:
When writing a register, the highest bit must be set to 1. The mclk is set to "1" by default, it will keep the last output signal magnitude. Once the DAC is set to 1, it stops the Unit output.