Network Over COM.LTE User Guide

1.Preparation

• Refer to the UIFlow Web IDE Tutorial to understand the basic process of using UIFlow and complete the installation of the M5Burner firmware burning tool.
• Burn the UIFlow firmware corresponding to the controller you are using through M5Burner.
• Insert the MicroSIM card into the module slot, adjust the DIP switch to enable pins 13,5, and connect the external antenna. When using the CORE1 device, please adjust the DIP switch to pins 13,5, and for CORE2, adjust the DIP switch to pins 16,17.

2.Set APN/Switch Mode

1. Connect the controller to the computer, click on the Configuration option in M5Burner, in the pop-up configuration box, set the COM.X option to True, configure the operator and APN corresponding to the SIM card, and then click save.

3.Start Using

1. After the configuration is complete, the device will automatically enable upon startup and begin to check. After passing the test, it will enter the programming mode page.